RINCO ULTRASONICS AG HW35-3 Manuel de service

Operating ManualHand Welding UnitHW35-3Englishwith generator SL35

104 Product information4.1 Product overview/technical data4.1.1 Hand welding unitHW35-31Housing2 Trigger key3 Horn (customer-specific)4 Hanging clip5

114.1.2 Ultrasonic generator SL351Housing2 Generator plug-in module3 Type designation of the plug-in moduleDimensions in mmWeight: 7 kg4.1.3 Available

125 Control and display elements5.1 Hand welding unit1 Trigger keyKey for activating the ultrasonic.Do not touch the horn when ultrasonic is emitted!2

135.3 Ultrasonic generator SL3526 Generator module plateThe generator module can be removed onto theseplates if necessary. The fixing screws (34) for

1430 “US-Test” keyKey for activating the ultrasound test.The current oscillator frequency is displayed. If thekey is pressed for more than 5 seconds,

156 Initial operation6.1 Choice of locationSelect an operating location for the equipmentaccording to the following criteria:• Clean surroundings• Vib

167 Retooling7.1 Basic setting of the generator for manual unitIf you hold down the “SET UP” key during start up(boot up of the LED bar), you are aske

177.3 Selection of amplitudeThe amplitude A (half an oscillation amplitude) canbe changed if necessary using “SET UP” and thecursor “vertical”. 7.4 Am

188 Cleaning and service8.1 General service workCleaning and maintenance work may only be carried out by trained personnel.Before beginning the mainte

198.4 Oscillator systemWork on the oscillator system (S1) only if the sup-ply voltage is switched off! High-voltage!Avoid contact with the RF socket (

Copyright by RINCO ULTRASONICS AG, SwitzerlandVersion 2.0, gb, Art.-No. 355512DisclaimerThe information in this brochure corresponds to our current st

209 Internal unit service9.1 Fuses for generator SL35Fuses are located in the following componentgroups:Power socketPrint busGenerator moduleAll fuse

2110 Error messagesand troubleshootingTroubleshooting can only be performed by speciallytrained personnel. If there are uncertainties, contact the ser

22Error“OVERLOAD 1”The generator was loaded more than 100% of the nominal power.“OVERLOAD 2”The generator had to use thepower reserves of the end lev

2311 Service addressesThe technical customer service of RINCO ULTRASONICS will be pleased to be of assistance incase of technical interferences and we

24RINCO ULTRASONICS AGIndustriestrasse 4CH-8590 Romanshorn 1SwitzerlandTel. +41 71 466 41 00Fax +41 71 466 41 [email protected]

3NoteThis operating manual must be read and observedbefore unpacking and initial operation of theunit. The unit may exclusively be operated and servic

Table of contents1 Explanation of symbols and signs 62 Safety information 72.1 General information 72.2 Intended use 72.3 Improper use 72.4 Important

5Important!In case of enquiries concerning your unit please state the exact type designation and the unit serialnumber.You will find these on the type

1 Explanation of symbols and signsSpecial attention must be paid to text sections withthe following symbols:Set-up of the warningsNote! Information or

72 Safety information2.1 General informationThe construction of this unit corresponds with state-of-the-art technology and is safe to operate. The ind

Danger!There is high voltage in the interior of the unit –risk of injury!• Refrain from all methods of working which couldpose a risk to safety!• Only

93 TransportationIt is essential to observe transportation instructionson the packaging.3.1 Acceptance of deliveryThe despatch container for machines